PLASTIC PANEL - how to apply

High quality outdoor graphics that are UV light and weather resistant. Can be installed inside too!!

INSTALLING PLASTIC PANELS INSIDE

Signs manufactured on tough 3mm Plastic Panel are very easy to apply. Supplied complete with sticky fixers.
*Apply sticky fixers to the back of the panel (as required).
*Peel of the backing of the sticky fixers and press the panel firmly against the wall.

INSTALLING PLASTIC PANEL OUTSIDE

When installing our signs on the outside is recommended to drill holes and use screws.
You'll need: drill, masonry bit, stainless steel or brass dome headed screws, nylon washers, screwdriver

*Drill 6mm diameter holes around the edge of the panel, about 6cm in from the edge and about 15-20cm apart.
*Position the panel against the wall and mark up where to drill holes.
*Fix the panel securely to the wall using dome headed stainless steel or brass screws.
*Panel should only be installed on a smooth, sound wall and should be checked regularly to ensure they are in good condition and safe.
Do not install at high level.
Do not install in exposed locations or onto any type of fence.